The Seasonal House
22 Nov 2026

Looking after a timber deck

A timber deck is the most weather-beaten part of many houses. It is flat, it faces the sky and it is wet half the year and baked the other half. A deck that gets a small amount of attention each year will last much longer than one that is left until the boards go soft, and the checks matter for safety as well as looks.

This guide covers what the weather does to a deck, a routine that fits the seasons, and the point at which a deck stops being a weekend job.

What the weather does

The BRANZ Good Repair Guide for timber decking puts the problem simply. Regular wetting and drying makes timber swell and shrink, and together with UV exposure and temperature changes this leads to deterioration (building.govt.nz Good Repair Guide: timber decking). The guide notes that slat decks are usually fully exposed to the weather and have gaps of 3 to 6 millimetres between boards to let water disperse, while the decking on villas and bungalows is typically tongue and groove, laid with a fall to the outside to shed water.

A BRANZ BUILD article on timber decks adds that the same cycle stresses both the timber and the fasteners, so popped nails and loose boards are among the commonest signs of age (BRANZ). If the gaps between boards fill with leaves and dirt, water stays on the surface and in the joints, and that is where rot starts.

Safety first: more than appearance

The Ministry of Business, Innovation and Employment is blunt about decks and balconies. Its guidance says that structures supported by untreated, kiln-dried timber may pose a safety risk, that the danger is greater where water collects instead of running off, and that decks and balconies need ongoing upkeep for their whole life. It also notes that a building consent is needed for decks and balconies more than 1.5 metres above ground, and that being consented does not guarantee safety (building.govt.nz).

For an owner, the lesson is to look beyond the surface boards. The parts that carry the load, namely the joists, bearers, posts and the connection to the house, are underneath, and that is where hidden rot does harm. A deck that bounces more than it used to, or feels soft at an edge, deserves a closer look.

An annual check

Pick a dry day in spring or autumn and work through the deck from top to bottom.

  1. Sweep and clear the gaps. Use a thin stick or an old knife to clear leaves and dirt out of the spaces between boards.
  2. Check every board. Look for cracks, splits, cupping and warping. Push a screwdriver into suspect spots; if it goes in easily, the timber is soft.
  3. Check the fixings. Look for popped nails and corroded screws or nails, and make a note of where they are.
  4. Look underneath. If there is access, check the joists, bearers and posts with a torch. Look for dark staining, soft timber and any place where water collects.
  5. Check the edges and the connection to the house. Look for gaps, movement and water staining where the deck meets the wall.
  6. Test the balustrade and handrails. Push them firmly. Any wobble needs fixing straight away.
  7. Check the drainage. Water should run off the deck and away from the house, not sit on the surface.

Cleaning and moss

A shaded, damp deck grows moss and mildew, which makes boards slippery. The BRANZ article lists removing moss and mildew through cleaning among the typical maintenance tasks. A stiff broom and a bucket of water with a mild detergent will do most of the work. Be careful with a high-pressure cleaner, because it can roughen and splinter the surface of softer timbers, so keep the nozzle at a distance and stay within what the timber can take.

Cutting back overhanging branches and keeping pots off the boards helps, because the damp patch under a pot is a favourite place for rot to begin. Raise planters on feet so air can pass beneath them.

Typical repairs

The BRANZ article lists the repairs most decks need over time:

When you replace a rotten board, look at the joist beneath it. If the framing under rotten decking is also rotten, the problem is bigger than the board.

Replacing a few boards, refixing nails and clearing the gaps are reasonable jobs for a competent owner. Work on the structure, on the fixings that connect a raised deck to the house, or on any deck high enough to need consent, is not. That includes decks more than 1.5 metres above the ground. If you are unsure, ask a builder or a building surveyor to look at it.

Finishes

Timber decks are normally given an oil or stain so that they last and look reasonable. Most manufacturers say to apply the finish to clean, dry timber, and to follow the instructions on the can for the number of coats and the drying time. Choose a finish designed for decking, and check the manufacturer's recommended re-coating interval, since it varies with the product and with how much sun and rain the deck gets. Oiling in a spell of fine weather in autumn or spring is easier than in the middle of summer, when the sun dries the surface too fast, or in winter, when it will not dry at all.

When it is time to stop patching

A few signs suggest a deck has had its day:

A deck is a structure, and some failures happen without warning. If any of these signs are present, close it off and get a professional assessment.

A deck calendar

Sources

Also this year:
The Seasonal House: a year-round home maintenance guide for Auckland and northern New Zealand. General guidance only; check current rules and product labels.