Using a dehumidifier well
A dehumidifier is a useful tool and a poor excuse. It can pull a lot of water out of a damp room, but it does not mend a leak, and it will not make up for a wet clothes horse in the bedroom. Used well, it lowers the number of damp days that mould and dust mites depend on. Used badly, it runs all day, dries out your throat and fills a tank you forget to empty.
NIWA describes Auckland summers as warm and humid and winters as mild, and Tenancy Services says damp and mould problems are most likely in autumn and winter. The following advice is based mainly on Consumer NZ's testing and guidance.
Know where the moisture comes from
Before switching one on, it helps to know what is feeding the problem. Consumer NZ lists typical household sources: drying a load of clothes indoors puts about 5 litres of water into the air, cooking about 3 litres a day, showers and baths 1.5 litres per person per day, washing dishes 1 litre a day, and breathing about 0.2 litres per hour per person. Mould is most likely when warm, moist air from showers and cooking meets cold surfaces and condenses.
That list says where to cut the moisture at its source:
- dry washing outside, or in a garage or carport, rather than on an indoor rack;
- use the rangehood or extractor fan when cooking, and open windows;
- put lids on pots;
- wipe condensation off windows and walls as it forms;
- avoid portable unflued gas heaters indoors, which make the air damp (Consumer NZ, top tips for avoiding mould in your home).
Healthify lists building leaks and faulty plumbing among the causes of damp, and no machine will outrun a leak.
Where to put it
Consumer NZ's advice is that dehumidifiers perform best for general dehumidifying when placed in the centre of a room with doors and windows shut. If you are drying laundry indoors, put the machine near the drying rack, ideally in a small room. Leave enough space so that the air intake and outlet are not blocked.
Vacuum the room first, because otherwise the filter can clog up quickly.
What to set it to
Many models have a humidistat, which works like a thermostat for humidity. Consumer NZ recommends setting it to 30 to 50 per cent. That range effectively limits dust mites and reduces the growth of mould and bacteria, which can cause health problems and damage the house. It also warns that removing too much moisture from the air can leave you with dry skin, throat and eyes, so there is no gain from setting it as low as it will go (Consumer NZ, getting the most out of your dehumidifier).
If your machine has no humidistat, a small hygrometer from a hardware store lets you see what the room is doing, and run the dehumidifier only when needed.
Run it with the heating
In the colder months Consumer NZ suggests using the dehumidifier at the same time as your heat pump, woodburner or electric heater, which helps it to extract moisture faster. Heat pumps and woodburners also keep a home drier in their own right. Warmer air holds more moisture, which makes condensation harder to form, so heating and dehumidifying work as a pair.
Some heat pumps have a dry mode. Consumer NZ mentions it as an alternative if you do not have a dehumidifier, so check your remote before buying a second appliance.
Ventilate too
A dehumidifier works best in a room that is not constantly refilled with damp air. Consumer NZ recommends running an extractor fan for about 10 minutes after cooking or showering, opening windows for 10 to 15 minutes each morning to bring in dry, fresh air, and keeping beds and furniture away from walls so that air can circulate. Healthify's advice is to check that extractor fans and rangehoods vent to the outside, rather than into the ceiling space.
Close doors and windows while the dehumidifier runs in a room, since an open window defeats it.
Look after it
The water tank and filter need regular cleaning in line with the user manual. A dirty tank and filter run less efficiently, and can circulate mould, bacteria and dust around the home. Empty the tank every day, and before putting the machine away at the end of the season, always empty and dry the tank. Check the model's manual for how often to clean the filter, because dusty homes and pets can shorten the interval.
When a dehumidifier will not be enough
If a room stays damp despite the machine and ventilation, and mould keeps returning, the cause is probably in the building rather than in the air. Healthify lists building leaks, faulty plumbing, flooding and little or no airflow in areas like cupboards as common causes. Tenancy Services says that if a rental stays damp and mouldy after you have done everything right, talk to the landlord, because hidden dampness can cause expensive damage, and a qualified building surveyor may need to check the property. Poor insulation and missing subfloor moisture barriers are other possibilities.
A weekly routine
One simple pattern for a damp winter: run the dehumidifier in the main living space on the days when you are home and the heating is on, empty the tank each evening, open windows briefly each morning, and move the machine to the bedroom or the drying room as needed. In spring, clean it, dry the tank and store it where you can find it when the first long wet spell arrives.